Take the 2-minute tour ×
Graphic Design Stack Exchange is a question and answer site for Graphic Design professionals, students, and enthusiasts. It's 100% free, no registration required.

Almost all of my design requirements are given in millimeters, not points, pica, or any other classical measurement. I design for board games, and the printer's specs always list their requirements in terms of millimeters of margin and bleed, not points and pica.

I'm making the jump from doing my layouts in Illustrator (which is happy to think in mm) to InDesign (which everyone assures me is the best program to do layouts in). But InDesign's insistence on converting every measurement I put into it to being in points and picas is wrecking my workflow.

How do I convert InDesign to defaulting to measuring dimensions in millimeters rather than points and picas?

share|improve this question
    
FYI, for board games, packaging, or anything that's not a multiple page layout, you may not find that you gain much with InD. In fact, you may just really miss the drawing features. I think InD is great, but I don't use it much when I'm just creating a lot of art in a non-book/magazine/brochure format. –  plainclothes Dec 3 '12 at 4:21
    
There's places in board game design I'm hopeful InDesign will show its value: 1) Punchboards: Since you pay an up-front cost for every die-cut pattern, it's common to swap the art on a punch-board and leave the die-cut patterns the same. InDesign's framing features should be good here. 2) Decks of cards. 3) Rulebooks And in general, I'm hopeful InDesign won't choke as much as Illustrator when I start pasting in large numbers of high-res raster objects, like the art for the tokens on a punchboard. InDesign should be better optimized for that. –  baudot Dec 3 '12 at 9:52
    
InD isn't going to be happy with you either when you start pasting things in. In InD (as with Illy) you should always place graphics as links. InD is actually a little more prone to corruption if you start doing messy things like copy & paste. In full disclosure, I haven't done much with InD since CS3 -- a little CS5, but no 6. –  plainclothes Dec 3 '12 at 17:16

1 Answer 1

up vote 13 down vote accepted

With Indesign open but no document open go to Preferences > Units & Increments and set the drop down menus to Millimeters.

Indesign will then use MM as the default.

This won't change existing documents, but it will change any new document.

measurements

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.