Take the 2-minute tour ×
Graphic Design Stack Exchange is a question and answer site for Graphic Design professionals, students, and enthusiasts. It's 100% free, no registration required.

Does anyone now how in inkscape how to pull things sort of inward? As an example, I am trying to take the following image (source) and pull the yellow teeth more towards the middle so text can fit in.

Sample image:

share|improve this question
add comment

2 Answers 2

Depending on your actual object, you might be able to select the inner points with the Edit Paths by Nodes tool (F2) and then click the Show Transformation Handles for Selected Nodes button in the upper right. Then you can scale those points smaller without affecting the outer ring. The geometry might get thrown off a bit if the gears are too close together... menu for handles

Edit: You can either select the inner teeth by lassoing while holding Shift to stretch them out... Or it is easier to break the paths apart and then just select the outer circle and make it bigger... Both results are shown below...

teeth moving in Circle moving out

share|improve this answer
    
I would like to bet able to do this with symmetry, and there are a large number of teeth. –  PyRulez Sep 12 '13 at 22:28
    
You can get symmetry by holding Shift and Control as noted in @thomasrutter's answer. Is it this exact image that you want to modify, or something like it? –  beroe Sep 13 '13 at 0:39
    
Actually, I was using it as the base for another image. (Do not worry, it is public domain.) –  PyRulez Sep 14 '13 at 19:51
add comment

This is how I'd do it.

  1. Separate the yellow shape into its two disconnected objects using Path -> Break Apart.

    At this point it may become harder to see the objects so you can switch to wireframe mode with Ctrl+Numpad5 twice.

  2. Deselect everything then select only the teeth, not the surrounding circle.

  3. Shrink this symmetrically and from the centre by dragging one of its corner points while holding Shift and Ctrl.

  4. Combine the two objects again by selecting them both and going to Path -> Exclusion.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.