I've been an avid reader of the site and now asking my first question. In regards to setting up baseline grid for multi column layouts, with a mix of type and image per page like a magazine spread. the process, which I'm interested in hearing about from designers. First, work out what the headings and body copy will be, then use that leading for the body copy as the base for the baseline grid? But I've read that using a half measure of the body copy leading is good practice as this will allow for space after issues. So once that is setup is there a general rule of thumb as to what the space after should be? The headings/ sub headings should be in regards to leading ?

thanks peeps!!

1 Answer 1


As you suggest, if in doubt using the body copy’s leading is always a good starting point. I find myself using one of three approaches:

A baseline grid based on body copy leading - the easiest to work with. Smaller and larger type can be anchored to the grid and will ideally have leading that is sympathetic to the baseline grid.

A baseline grid that is a fraction of the body copy leading - this is useful where I’ve got a lot going on. I used this recently within a document that had a lot of images and figures/captions. In this case it helped keep things neat and easy to work with.

A baseline grid that fits the wider page grid - ideally they all will. In practice this can often be harder than it sounds. (I’ve often had baseline grids that are a point or two (or much more!) out when I get to the foot).

Which one you choose depends on what will make your life easier rather than something that seems right but is a pain to use. What works also varies from document to document. The key point to remember is that no one will ever see your baseline grid (directly). They will see the impact it has on your work - which is, ideally, rhythm and consistency.

[EDIT: You also asked about headings and subheads relative to baseline grid. I’ll usually set up a heirarchy of heading sizes (and caption, etc) sizes relative to the body using a clear scale. That means that their leading will likely be a multiple of the body’s. This means that a heading might sit on the baseline grid every 3 lines, etc.

Your question here probably relates to the space between a heading and body copy. This is easy when all headings are one line but more complex when they are multi-line and vary throughout a document. There are a handful of ways of working with this. Again, which is right depends on the work you are producing. Basically:

  • you can make the heading leading match the baseline (or be a clear multiple of it - 2x, 3x, etc)
  • you can set up a default heading area (or areas) that is always clear of the body.
  • you can fudge it and add enough space around the headings that people won’t notice a part-line more or less around some headings.

Probably not quite as clean an answer as you were hoping for, but it’s challenges like this that (knowingly or not) people hire us to solve]

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge that you have read and understand our privacy policy and code of conduct.

Not the answer you're looking for? Browse other questions tagged or ask your own question.