0

I think my problem has a very simple solution but I couldn't find it. My join tool can trim excess parts of a path but it does not extend the paths and join them where they intersect. What am I missing?

doesn't extend

trims well

closed as unclear what you're asking by Scott, Lucian, Billy Kerr, Paolo Gibellini, Luciano Jan 3 '18 at 9:12

Please clarify your specific problem or add additional details to highlight exactly what you need. As it's currently written, it’s hard to tell exactly what you're asking. See the How to Ask page for help clarifying this question. If this question can be reworded to fit the rules in the help center, please edit the question.

1

The problem is that the join tool only works when there is path data for it to connect.

enter image description here

Your ends are acting like to parallel lines | | there's no horizontal points for it to read to connect. You need a path that has some horizontal point for it to read like this |_ |

  • 1
    I've been playing with the Join tool since seeing this question. It's new to me. .. what a waste of development time it is :) Select the anchors.... command-J done. No too switching. :) Nice call on the answer though :) – Scott Jan 2 '18 at 19:18

Not the answer you're looking for? Browse other questions tagged or ask your own question.