I am new to graphic design and my information is very limited
After I have done the curve I noticed that it is not smooth curve
How can I change it to become smooth with same line width all over the line
4
-
2It looks like you have some kind of path effect on the path. Try this: Select only the path by using the Edit Paths by Nodes Tool (F2). Click Path > Remove Path Effect– Billy KerrAug 26, 2019 at 21:25
-
The solution in the above comment by Billy Kerr is more recommendable than the accepted answer, as it does not require redrawing.– MoiniAug 27, 2019 at 14:02
-
@Moini I tried it, but it did not work !– asmgxAug 27, 2019 at 16:41
-
Did you use the calligraphy tool to draw that line, then? I was assuming you used the Bézier tool in the wrong mode.– MoiniAug 28, 2019 at 10:51
Add a comment
|
1 Answer
Based on the displayed image, you may have selected the incorrect tool from the palette. If you pause over each tool, a tool tip will appear to display which one has been selected. It is going to be necessary to re-trace your curve rather than convert it, but you should find that easy enough to accomplish.
I made a brief attempt to trace your curve, without creating much smoothing. There's quite a bit of control with the handles of the curve tool:
answered Aug 26, 2019 at 17:21
-
This is the tool i choose.. but when I increased the width of the line it became as in the image– asmgxAug 26, 2019 at 17:28
-
Can you display or otherwise present the Stroke/Fill settings you are using? Aug 26, 2019 at 17:36
-
-