10

I'm trying to create a 3D extrude of an ABS pipe elbow like this:

Example image

Large image.

Although it can be solid, isn't necessary for a hollow pipe.

I created a doughnut from two ellipses (one deleted from the other), then took a quarter of that ellipse (the elbow) and extruded--it looks similar, but it's edges are straight not rounded. I realize I could just create the same look with the pen and mesh gradients, but I'm going to be using the pipe elbow numerous times and at different angles, so I figure this is the quickest way to a reusable object.

Improve this question

2 Answers 2

Reset to default
10

This is actually easier than you think :)

Start with a circle shape, then go to 3D -> Revolve.

I love donut

Turn on preview checkbox, play with the options. You'd start with a full donut first. Adjust the Angle amount. you can also play with the Offset.

Improve this answer
2
  • 1
    Very nice. I was playing around with Revolve, but I swear my object didn't look like this! I'll have to go back. Thank you for the quality print-screen answer.
    – Graham T
    Commented Jun 27, 2011 at 17:33
  • Good tip with revolve options, I used it in my work, Thank You! Peace :)
    – user24221
    Commented May 26, 2014 at 9:16
0

Make sure you select the correct edge. Each one will have a different outcome.

Improve this answer
0

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.