I am a relative sketch / design newbie. I am trying to creating a simple check mark icon embedded in a green circle.
The problem is the clipping on top of the circle on all sides. My sketch file organization looks like this.
It is basically two lines at an angle and an oval. I tried using the oval as a mask and without mask. Not sure what I am doing wrong. The figure looks good on sketch
The sketch file is uploaded on dropbox here.
The Problem is that your circle is bigger than your artboard.
The circle is 24 x 24 px big as well as your artboard. But you have a border of 1px around it, which is center aligned. This means your circle is actually 24.5 x 24.5 px big. So when you export your icon 0.5px will be cut away.
So what you can do is either delete the border by unchecking the checkmark in the Borders section or you can increase the art board size. You can do this by clicking on your artboard (in your case Edit Circle Selected) in the outline panel on the left and adjust the size on the right.
Change border 'position' from 'center' to 'inside'. It will help.
