1

If I try to delete some pixels, then I select rubber tool and set hardness to 100%. However, I still have to click about 4-5 times at a pixel so that it completly removes and turns to alpha.

Why is this the case and how can I solve it?

It does still not delete all inside my circle on one click , even if everything is on 100% enter image description here

  • Due to slight inaccuracies with Wacom devices, it's possible multiple clicks are needed so the tablet actually reads movement. I know that for a single pixel, I need to tap and wiggle the stylus a little, not just tap. -- All depends on the actual driver version from Wacom though. Some versions are better than others. – Scott May 29 '17 at 21:15
  • I only use mouse, but thank you, maybe someone else will find this helpful sometimes! – Black May 29 '17 at 22:18
  • 1
    Maybe it's an inaccuracy in Photoshop and not the Wacom device after all. I just assumed it was Wacom since I've been using that for years. I'd at least try wiggling the mouse a little with the button held down. – Scott May 29 '17 at 22:38
7

It sounds like either the Flow or Opacity has been reduced. Make sure both are at 100% and then it should work on a single click if you also have the hardness set to 100%.

update:

Given the new comments and screenshot change your Eraser's mode from Brush to Pencil and then it will work how you want it to.

  • @Black updated my answer for you, think that'll solve your problem – Ryan May 30 '17 at 17:01

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.